The way to Fill Grooves in Wood Paneling
Wood paneling is a retro wall covering which required no prep work into the wall’s unique surface and was easily applied in sheets with little paneling nails to fasten. Old paneling is frequently dark and has gone out of favor with most interior designs. While painting paneling is a simple solution, many homeowners prefer a smooth wall without vertical paneling grooves. Fill the flux of this paneling to create a smooth canvas to transforming your room’s decor.
Eliminate as many furnishings from the room as possible. Remove everything from the paneled walls, including nails for hanging photos, trim and socket covers. Cover sockets with masking tape to stop dust from seeping to the electrical slots. Cover any furniture with cheap paint tarps. Hang vinyl paint tarps over doors and tape the edges to stop dust from filtering from this room.
Sand the paneling working with an electric palm sander. Sand the paneled surface till the masonry shine and stain color is eliminated. You do not need to wash out the walls before this measure. The sanding process will also eliminate grime and stains which naturally happen on the paneling surface from years of use. You may have sanding dust everywhere.
Vacuum the walls with the hose attachment on your vacuum. Wipe the remaining dust from the wall with a damp rag. Don’t uncover your furniture or doorways.
Paint only the grooves of this paneling using latex wall primer. Through the years ecological stains become trapped in the timber, as old paneling is quite porous. A primer which specifies covering stains is recommended. Allow the primer to dry.
Put some spackling paste on a plastic tray using a putty knife. Sprinkle the stack with water and mix it to the paste using the knife. The water is likely to produce the spackling paste easier to handle.
Subscribe to a manageable amount of the paste in your own putty knife. Beginning at the top of the paneling, scrape the knife over a groove. Scrape downward, filling the back with paste as you go. Dip the end of the knife in water and scrape on the moist paste to smooth it flush with the wall. Duplicate on each of grooves. Allow to dry.
Sand over the dried spackling paste using a sponge sanding block to smooth and mix the groove even with the remaining paneled wall. If the spackling paste has escalated to the flux, apply another coat, allow to dry and mud.
Prime and paint the paneling as desirable.